Over the years, you put a lot of coats of paint on your walls. It creates a layer of thickness that, when it gets too big, is creating a rather uneven surface on your wall that can be spotted immediately. It also can happen that your paint starts to drop out of your walls, ceilings first, leaving a big mark that is revealing your previous paint color. Then you have t for sure remove all layers of old paint before applying a new color.

How to prepare

The process begins by removing all electrical switches in the room where you are removing the old paint. You also need to remove all the masked sockets. And that’s enough. No need to remove the body from the socket itself. In this way, you have released the surface for work. Of course, it is necessary to remove shelves, paintings, etc. from the walls. Of course, you must turn off the power before any interventions. The easiest way is to turn off a certain fuse that interrupts the current circuit in which the sockets and switches are located. It is important that the electricity remains off during the entire work. Since water is used in this process, it would be extremely dangerous to have voltage on the leads you released after removing the switches and sockets.

The process itself

paintLet’s start slowly. Pour the water into a larger bucket and add the kitchen salt to it. There is not a certain measure so about a hand on a bucket of water should be just the right amount. Mix it until the salt is completely dissolved. You should soak the walls and leave them for some time so the water can penetrate the deeper layers of the old paint. In preparation, it is important that the wall be well watered and wait at least 5 minutes or more for the water to pass as deep as possible through the paint. In some cases where the paint layer is very thick, you will most likely have to do the procedure with soaking and swallowing in several stages.

The salt in water multiply that affects and the removal of paint from the wall will be easier, while it is retaining moisture and sagging the paint. You can soak the water with a roller or a brush. Also, it’s a good idea to get a bottle with a water pump. With it, you will very easily soak walls with water. It is especially useful for ceilings because there is no water leakage, as with a roller. After that, you still need to do that boring and difficult job, and that’s just scraping paint with a spatula from the wall. You will notice that the paint around the chandeliers and the bulb are much harder to remove because it is baked over time under the influence of the lamp temperature. Also, you will see that in places where there was moisture the paint is almost getting by itself.